Centrix SA1DK Manuel d'instructions télécharger pdf (Page 11)

12.1 Entering Programming Mode

1. Press the # key for two seconds.

The Mode LED turns off and the Door LED turns red.

2. Enter your 4-digit Programming Code.

If the Programming Code is valid, the door LED turns

green and the SA1DP goes into Programming Mode.

Note : The SA1DP must be in Normal Mode in order to enter the Programming Mode.

Programming Mode.

The factory default Programming Code is 1234.

If a Programming Code is not entered within 5 seconds, the SA1DP returns to Normal

Mode.

12.2 Exiting Programming Mode

To exit the Programming Mode at any time:

1. Press the # key for two seconds.

3 beeps are emitted.

The Door LED turns off.

The Mode LED turns green, indicating that the SA1DP has returned to Normal Mode.

Note : Wrong entries may reset the controller back to Normal Mode.

While in Programming Mode, if no key is pressed for one minute, the SA1DP exits

programming mode and returns to Normal Mode.

In certain Programming Modes, a quick press on the # key may also return the system

to Normal Mode.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Pas de commentaire

Centrix SA1DK Manuel d'instructions Page 11